Dear ER students,
Here are the some additional instructions for printing your parametric joints. Follow in general the corresponding video tutorial from Robogen.org (http://robogen.org/docs/video-tutorials/) BUT use the following parameters:
1) use LEFT extruder
2) layer height - 0.25mm, first layer height - 0.25mm
3) infill - 25%
4) print speed - 40mm/s
5) Temperature: extruder - 230C, platform - 100C
Make sure the platform is clean before starting the print. Remove any remaining plastic with a cutter carefully (do not damage the platform surface)
If you still having problems printing send me an e-mail, call 30041 or come to my office MED1 1315. You can also send Skype messages to "gud_alex".
Have fun with your robots!
Olexandr
