Lab2 part 1.1, question 3

Lab2 part 1.1, question 3

by Antoine Tappy -
Number of replies: 1
Good afternoon,

I have a question regarding the question 3 of the lab 2 part 1.1.

The instructions are to capture data on the eth0 interfaces of the four hosts. Unfortunately on my wireshark I can only see the switches interfaces : s1-eth1, s1-eth2, s1-eth3, s2-eth1...

Did I miss something or do we need to observe data on the switches interfaces ?

Thank you, have a nice day

Antoine
In reply to Antoine Tappy

Re: Lab2 part 1.1, question 3

by Joseph Abboud -

Hello,

Which terminal are you opening Wireshark from?

If you run `wireshark &` inside the terminal of each host (h1 to h4), you will see their respective eth0 interface.

Regards,
Joseph